The Elektor Forum will close. See also this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

Trying to interface 2n5551 with arduino

The topic on number crunching

Trying to interface 2n5551 with arduino

Postby teprojects1 » Wed May 09, 2018 11:43 pm

Hi,

I am working on a project in which I need to drive two small DC Motors with Arduino. So, now I am designing a motor driver and I want some suggestions about it. I am thinking of using 2n5551 so would it work or not. I have read about 2n5551 Pinout from this link and i think it will work out. So, need suggestions???

Thanks.
teprojects1
 
Posts: 14
Joined: Wed Nov 23, 2016 1:44 pm

Return to Microcontrollers & Embedded

Who is online

Users browsing this forum: No registered users and 1 guest