The Elektor Forum will close. See also this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

Plation Soldering Station - can I trust it?

Equipment, circuits, projects, procedures

Plation Soldering Station - can I trust it?

Postby ULfholt » Thu Sep 28, 2017 4:41 am

I have built some of these stations, and I'm not sure I can trust this thing. Two times the expensive soldering tip has burned up (suddenly got red and then stopped working) and I cannot tell why. Last time it happened, I saw the tip starting to get red and I managed to swithc it of. When I tried to turn it on after a few minutes, it worked OK for a while, but then suddenly, while I was getting something from my book shelf, the same thing happened, and I was to late to save the tip.

Have anyone had the sane experience, and can someone tell me why this is happening? I have not made any modification to the project and I'm using the recomended parts, though I have purchased most of the parts from eBay.

Best regards

Ulf Holt
ULfholt
 
Posts: 4
Joined: Thu Jun 16, 2016 7:54 am

Return to Test & Measurement

Who is online

Users browsing this forum: No registered users and 0 guests