The Elektor Forum will close. See also this link. From Friday March 15st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

Platino different versions

Equipment, circuits, projects, procedures

Platino different versions

Postby ULfholt » Thu Jun 16, 2016 8:18 am

I have just started buildig Solering Station project using the 1.3 version of Platino PCB. I find these cards a bit expecive, and can produce them myself for a much lower cost, if I have access to the gerber files. I found the gerber files for the original version, so I have the following question:

1. Are there gerber files (or Eagle files) available for newer versions, and if so where?
2. What are the differences of the versions?
3. If I cannot get the files for the newer versions, is there any use in making a bagde of the original version?

Best regards

Posts: 4
Joined: Thu Jun 16, 2016 7:54 am

Re: Platino different versions

Postby Elektor Editor » Tue Jun 21, 2016 12:31 pm

Ulf's query is answered in detail here: ... ments/4675

Elektor Editor
Posts: 467
Joined: Thu Jan 02, 2014 10:36 am

Return to Test & Measurement

Who is online

Users browsing this forum: No registered users and 0 guests