Atmel Studio 6 won't communicate with D20

ARM fuer Einsteiger

Re: Atmel Studio 6 won't communicate with D20

Postby Evelien » Wed Feb 25, 2015 8:17 pm

Hi Viacheslav,

thanks for your suggestions. I have not loaded the UART program yet, I am still stuck on part 1.
I was just hoping to see a glimpse of the EDBG (or the ARM) in a terminal window to confirm I have communication with the board.
I also didn't have the terminal embedded in Atmel Studio yet. I have installed that now, but it seems a lot more primitive than Tera Term. It looks like that terminal does not even know what a DTR line is. In Tera Term I could at least choose a flow control (Hardware / Xon/Xoff / none) that would likely have an effect on the DTR line.

There are simply too many things that can be wrong between Atmel Studio and the connected board. A simple test to check the communication could help me to divide the problem into a "hardware + driver" side and an "Atmer Studio + configuration" side.

Best regards,
Evelien
Evelien
 
Posts: 4
Joined: Tue Feb 10, 2015 9:51 pm

Re: Atmel Studio 6 won't communicate with D20

Postby helitacker » Sat Feb 28, 2015 1:34 pm

Hi,

I had the same problem in Win 7 + 8 and I don't know why and how but meolsen's post in the AVR Freak Forum fixed it:
http://www.avrfreaks.net/forum/as62-new ... programmer?

Reinstallation of USB Driver: http://distribute.atmel.no/tools/AS6/dr ... .0.666.exe

I hope that helps somebody ...

Regards
helitacker
 
Posts: 2
Joined: Fri Feb 27, 2015 10:23 am

Previous

Return to ARM-COURSE

Who is online

Users browsing this forum: No registered users and 1 guest

cron