elektor lathe tacho project

Equipment, circuits, projects, procedures

Re: elektor lathe tacho project

Postby ag » Sun Jan 04, 2015 10:49 am

Hi Phil and Allan,

My "firmware " software has the "#define RPM_sensor_ line_Input 1 line. I did not change it.


I checked with the Arduino site and see that the Micro interrupt 1 is indeed connected to D03, so that was a blunder on my part.

Since Allan is seeing signals at the input pin, and did not have the problems Phil had with compiling, and since Phil´s project is working, I would suspect that Allan has a problem with the interrupt handling. I would recommend that Phil provide Allan with information regarding versions/sources of the the Adafruit/Arduino libraries he used for his compilation.

Good luck and best regards,
Ag
ag
 
Posts: 531
Joined: Thu Jan 02, 2014 10:37 am

Previous

Return to Test & Measurement

Who is online

Users browsing this forum: No registered users and 1 guest