The Elektor Forum will close. See also this link. From Friday March 15st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

LCR-meter bootloader version

Equipment, circuits, projects, procedures

Postby Guest » Fri Mar 07, 2014 12:00 am

Hi all,

Is it necessary to have a certain bootloader version for upgradig to firmware version V300 ?

I would not like to buy the flashing tool just for using once.

wolfgang
Guest
 

Postby snoopy_94 » Sat Mar 08, 2014 12:00 am

woHi all,

Is it necessary to have a certain bootloader version for upgradig to firmware version V300 ?

I would not like to buy the flashing tool just for using once.

wolfgang
Hi Wolfgang,
All versions of the bootloader are able to load any firmware, and after reboot to launch this new firmware.

Jean-Jacques
snoopy_94
 
Posts: 90
Joined: Thu Jan 02, 2014 10:48 am


Return to Test & Measurement

Who is online

Users browsing this forum: No registered users and 1 guest