The Elektor Forum will close. See also this link. From Friday March 15st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

The Elektor FT232R USB/Serial Bridge

Equipment, circuits, projects, procedures

Postby Guest » Fri Dec 27, 2013 12:00 am

Will this allow a legacy hand-held oscilloscope (an OsziFOX from Plco Technology), with a two-wire serial output (SIG, GND), to transmit data via the USB port to a laptop which has the relevant Plco software installed?

Return to Test & Measurement

Who is online

Users browsing this forum: No registered users and 1 guest