The Elektor Forum will close. See also this link. From Friday March 15st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

500ppm LCR: Bringup stuck at Sinus generator offest adjustme

Equipment, circuits, projects, procedures

Postby pwoods » Fri Aug 09, 2013 12:00 am

I'm following Version 23/04/2013 11:00:11 of the bring-up doc. When I get to step "6. PGA phase adjustments menu"
and I have J2 installed, I make the adjustment and click Save, but the value does not save. The phase returns to its original value.
Posts: 1
Joined: Thu Jan 02, 2014 10:48 am

Postby genuensis » Fri Aug 09, 2013 12:00 am

I had the same problem, I solved loading latest version from elektor site, but it has not been easy because in fact I got another problem then, the lcr stopped working and I had to modify the firmware.
You may read the long thread and my discussion with the author.
see: 500ppm LCR Meter won't trim

perhaps you will be lucky.
Posts: 7
Joined: Thu Jan 02, 2014 10:48 am


Return to Test & Measurement

Who is online

Users browsing this forum: No registered users and 2 guests