The Elektor Forum will close. See also this link. From Friday March 15st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

500ppm LCR Meter won't trim

Equipment, circuits, projects, procedures

Postby hadihf » Wed Sep 11, 2013 12:00 am

USB connector shell is digital ground. Bolt is Analogue. These are connected by one 0ohm jumper under the processor. You do not want to connect it anywhere else to avoid ground loops and interference. Also is better to sheild the dispaly if being used.

Regards
F
hadihf
 
Posts: 49
Joined: Thu Jan 02, 2014 10:37 am

Postby eguy » Tue Nov 12, 2013 12:00 am

It is not a stupid question, I am wondering the same. Can we please get an answer?
eguy
 
Posts: 18
Joined: Thu Jan 02, 2014 10:47 am

Previous

Return to Test & Measurement

Who is online

Users browsing this forum: No registered users and 1 guest