The Elektor Forum will close. See also this link. From Friday March 15st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

Elektor ESR / C Meter (September 2005)

Equipment, circuits, projects, procedures

Postby sonytel » Wed May 30, 2007 12:00 am

Hello.
1) I am testing the ESR/C meter and detected some inconveniences.
The point +Bat this directly connected one to the feeding of the OP LF412, and is not this tension interrupted by the switch S2. to that this is?
2) when I try to adjust the tension from Offset to 40mv, does this become impossible, does the same one vary since between 30 and 50 mv, is this variation due to that this present the sign of 200Kz? coming from the PIC16F84
3) when I try to measure the ESR of a capacitor, this he/she gives me among 0,7 and does he/she go ascending up to 3, is this normal? since comparing the measures with the Meter ESR published in Elektor 270 of 2002, the measure stays in 0,5 and it doesn't vary.
Then measuring a capacitor with an ESR value of 52 with in ESR to of elektor 270, november 2002, and when measuring it with the ESR/C tester, is the measure of 22, is this undoubtedly lagun problem in the adjustment of the tension of Offset?

Best regards
Gabriel Beguiriztain
Argentina
sonytel
 
Posts: 39
Joined: Thu Jan 02, 2014 10:44 am

Return to Test & Measurement

Who is online

Users browsing this forum: No registered users and 1 guest