The Elektor Forum will close. See also this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

Inductor - 22uH : Implementation

HiFi, LoFi, Tubes, Transistors, ICs, Commercial, DIY

Inductor - 22uH : Implementation

Postby shadders » Tue May 23, 2017 9:12 am

Hi,

With regards to the inductor of 22uH - the design uses what i assume is a toroidal core to create the inductor - increases the inductance per given number of turns.

I have not analysed the inductor behaviour, but i again assume that the toroidal core will have a specific B/H curve which although it may have a very low coercive force to magnetise the core, this will still introduce a non linearity to the circuit.

Was the inductor designed to have a small PCB footprint, hence the use of the toroid core ?.

If the PCB was redesigned for an air cored inductor, are there any design considerations or issues, in using an air cored inductor ?

I propose to use the following for a redesigned PCB :

TT Electronics : HA55L-3623220LF 22uH@100kHz, 34Amps power inductor.

Or a Jantzen air cored inductor.

Thanks and regards,

Shadders.
shadders
 
Posts: 60
Joined: Thu Jan 02, 2014 10:37 am

Return to Audio & Video

Who is online

Users browsing this forum: No registered users and 1 guest