Software issue Elektor Nixie Thermometer

The topic on number crunching

Software issue Elektor Nixie Thermometer

Postby jeg » Sat Oct 13, 2018 12:22 pm

Good afternoon,
I bought this kit: Nixie Bargraph Thermometer (Kit | 170589-71)

The hardware assembly was no problem, but the software downloaded from Elektor has (almost) no function.

Almost means: No operation on tube, no operation on the LEDs and only one line output in the serial monitor:
Settings: settings are undefined or invalid
This message comes on every start; I think it should come only once after first start.
I addition there is no reaction to any command given over serial monitor :(

I enable the debug switches in in_9_thermometer.ino. It seems all software parts are running.

To ensure there is no hardware issue, I wrote a small arduino test sketch and found all hardware parts (RGBs and tube) are working perfect.
Can anybody support with an idea?
Thanks in advance.
jeg
 
Posts: 1
Joined: Sat Oct 13, 2018 11:51 am

Re: Software issue Elektor Nixie Thermometer

Postby davidk350 » Sat Oct 27, 2018 11:11 am

Elektor’s June issue is going to be a classic. You’ll read about a wide range of topics from a Nixie thermometer/hygrometer to a PIC programmer solution to an Intersil IMS6100 vintage dev kit. And much more.
davidk350
 
Posts: 1
Joined: Sat Oct 27, 2018 11:04 am


Return to Microcontrollers & Embedded

Who is online

Users browsing this forum: No registered users and 1 guest