High Voltage Power Supply Design

The topic on number crunching

High Voltage Power Supply Design

Postby maryzhu » Thu May 18, 2017 6:19 am

Hello all. Thanks for taking up your time to read my post.

I need to charge a 1000uF 400V capacitor bank off of a 7V LiPo battery within roughly 5 seconds, and have the circuit be as small and light weight as possible. With a constant voltage supply and a resistor to limit the current, the peak current when the capacitors are discharged is around 200mA, and with a constant current power supply the peak current is around 100mA. The constant current supply would also make other parts of my circuit easier, so I would like to have the power supply current limited if possible.

The flyback converter seems like the best topology so far, but how does the flyback compare to other topologies like cascaded boost and boost with autotransformer converters for this kind of voltage?

Would constant current flyback controllers like the LM3880MF as the datasheet of http://www.kynix.com/uploadfiles/pdf228 ... MF-1AA.pdf work for this ? All the ones I can find seem to be designed for stepping down voltages from rectified AC power to a low voltage DC, and I'm not sure if it is possible to run the the opposite way.

There are a few other questions on here about high voltage supplies, but they're all limited to current levels in the uA, so I'd appreciate some direction.
Posts: 6
Joined: Fri Mar 03, 2017 2:09 am

Re: High Voltage Power Supply Design

Postby JohnnyP » Sun Nov 05, 2017 6:59 am

Search Linear Technology for photo flash ic's.

Posts: 2
Joined: Sun Nov 05, 2017 6:10 am

Return to Microcontrollers & Embedded

Who is online

Users browsing this forum: No registered users and 1 guest