Sandclock

The topic on number crunching

Sandclock

Postby hinz.a » Sat Dec 03, 2016 12:30 pm

I´ve build up one of the actuel projects, the sandclock, based on an Arduino Uno. I´m not e professional in programming. The initializing in Step 6 of the manual is free of errors. But the calibration after Step 31-32 fails. If I open the Arduino´s IDE´s Serial Monitor, an error occurs:

Reading EEPROM...
Invalid settings in EEPROM
Enter commands

The board himself is accurate detected, also the virtual port COM14, The BAUD-Rate is default 9600.
Can everybody help me?

Thank You so much,
Andreas
hinz.a
 
Posts: 2
Joined: Sat Dec 03, 2016 12:16 pm

Re: Sandclock

Postby hinz.a » Mon Dec 05, 2016 7:06 am

I have found the reason for the error. The problem was sitting in front of the keyboard.
hinz.a
 
Posts: 2
Joined: Sat Dec 03, 2016 12:16 pm

Re: Sandclock

Postby Paul van de Veen » Mon Dec 26, 2016 6:53 pm

I build sandclock and it is running nicely. But all text is tilted to the left for about 10 degrees.
How to correct?

Thanks!

Paul
Paul van de Veen
 
Posts: 1
Joined: Mon Dec 26, 2016 6:40 pm

Re: Sandclock

Postby SteveThack » Thu Feb 09, 2017 1:29 pm

SteveThack
 
Posts: 8
Joined: Sat Jun 28, 2014 8:22 pm

Re: Sandclock

Postby sageraus » Sun Feb 19, 2017 7:05 am

yes,The board himself is accurate detected, also the virtual port COM14, The BAUD-Rate is default 9600.
sageraus
 
Posts: 3
Joined: Sun Feb 19, 2017 7:02 am


Return to Microcontrollers & Embedded

Who is online

Users browsing this forum: No registered users and 1 guest