The Elektor Forum will close. See also this link. From Friday March 15st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

Led Candle doesnt blow out after being on for a minute +

The topic on number crunching

Postby barmed » Mon Jan 16, 2012 12:00 am

Hi

The LED candle project in Dec 2011 edition of Elektor magasine works but not after you leave the project on for say 45 secs or more then try and blow out the LEds. Can anyone tell me why as I thought the temp differential between blown air and temp of PCB after PCB had been on for a while would make it easier to blow LEDs out not make it impossible.
barmed
 
Posts: 2
Joined: Thu Jan 02, 2014 10:39 am

Return to Microcontrollers & Embedded

Who is online

Users browsing this forum: No registered users and 1 guest