The Elektor Forum will close. See also this link. From Friday March 15st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

GPIO support problem

The topic on number crunching

Postby britty » Wed Oct 19, 2011 12:00 am

The user manual of AT91SAM9261 says that it support GPIO interrupts for PIO A,B,C.
How do I enable these interrupts and handle them?
Do you have any example piece of code to share?
It is SBC6000X board based on AT91SAM9261 from Emest.
britty
 
Posts: 2
Joined: Thu Jan 02, 2014 10:43 am

Return to Microcontrollers & Embedded

Who is online

Users browsing this forum: No registered users and 1 guest