The Elektor Forum will close. See also this link. From Friday March 15st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

satfinder march 2011. Problems with atmega8

The topic on number crunching

Postby enzo » Sat Oct 01, 2011 12:00 am

I realized the satfinder published on elektor march 11. I loaded file.hex on a new atmega 8 by a self made serial programmer using ponyprog. Everything went weell but the satfinder LCD shown the software version only and noting else. I tried many time, using other atmega8-16 PU and other self made programmer but without success. All the atmega seem to be programmed but the satfinder does not work. I do not know if there are problems with atmega fuses set up. Sorry for my english. I am Italian
Many thanks for possible solutions
enzo
 
Posts: 1
Joined: Thu Jan 02, 2014 10:43 am

Postby Elektor Editor » Wed Oct 05, 2011 12:00 am

A valid GPS datastream is required for the program to start working.

Jan
Elektor Editor
 
Posts: 467
Joined: Thu Jan 02, 2014 10:36 am


Return to Microcontrollers & Embedded

Who is online

Users browsing this forum: No registered users and 1 guest