The Elektor Forum will close. See also this link. From Friday March 15st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

Warwick, chapter 10 DBGU problem

The topic on number crunching

Postby vopa » Wed Aug 24, 2011 12:00 am

Going through C Programming for Embedded micros by Warwick. chapter 10, comm via hyper terminal using the DBGU port.
Had to use a New Products USB to serial converter. Insatallation went well, but on transmission signal is corrupted. Instead of dispalying "Hello from DBGU", initial characters of "Hello" are corrupted....... cannot fathom what is going on. Any clues?
vopa
 
Posts: 4
Joined: Thu Jan 02, 2014 10:42 am

Postby vopa » Fri Aug 26, 2011 12:00 am

Problem solved.
Pls refer to "USB to serial Comm" message.
vopa
 
Posts: 4
Joined: Thu Jan 02, 2014 10:42 am


Return to Microcontrollers & Embedded

Who is online

Users browsing this forum: No registered users and 1 guest