The Elektor Forum will close. See also this link. From Friday March 15st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

Transferring elektor gerber RS-274D format to RS-274X

The electronics enthusiast's product design cycle

Transferring elektor gerber RS-274D format to RS-274X

Postby Tailgunner » Wed Nov 21, 2018 3:59 pm

I have some gerber files that were created by Elektor using ultiboard. Since these are old files they are in the RS-274D format.
My question is if somebody knows of any software that can do this migration from RS-274D to RS-274X and that can handle the old aperture file format used by ultiboard?
Posts: 6
Joined: Wed Nov 21, 2018 3:40 pm

Return to CAD, Simulation, PCBs, Making, 3D Printing

Who is online

Users browsing this forum: No registered users and 1 guest