Page 1 of 1

Colinbus PCBBox

PostPosted: Fri Apr 21, 2017 12:54 pm
by stevewidg
Hello All,
I have a PCBBox which is working on an OLD XP laptop which is on its last legs. I do not have a copy of the software, my stupid fault for not saving to a backup!!
Anyway I found this copy of software ( Norton said it was safe!!)
http://pcb-module.software.informer.com/download/
The machine I am trying to install on is W7 64 bit, I have tried installing in XP compatibility mode, and its installed in Programs(x86) folder. However the machine is not seen by software. As far as I can see it enumerates as an FTDI serial port, and I seem to have all the same name files from my XP machine, and although the software runs I cannot communicate.
Does anybody know if this software is ONLY 32 bit, or if there is something else stopping it working.

I saw someone asking about connector on back of PCBBOX, and this is a reply I got from then when they were still around, hope it might be useful to someone

Has anybody used MIPEC software? I tried the test version , but as it wouldnt output didnt want to buy, and they wouldnt provide a time limited full version.

Stevewidg

Re: Colinbus PCBBox

PostPosted: Wed Jan 03, 2018 9:42 pm
by omaroski
Hey there,

don't know if you already fixed the issue with your machine, i have PCBBOX too and newest versions of PCB Module (138, 141 and 142). I've used the machine both on Windows 7 64bit than 32bit with no problem.

I also have some documentation about PCB Module and PCBBOX. If you are interested drop me a line so i can email you things i have. Somewhere i should have a latest version of the firmware too.

By the way, thanks for sharing the rear connector pinout!

Omar

Re: Colinbus PCBBox

PostPosted: Thu Dec 13, 2018 8:33 am
by BLF
Hello everyone
I have a PCB BOX COLINBUS year 2013 . But I have no software to make it work. Is someone who owns these software and could provide it to me ?
Thanks in advance.
BLF

OMAROSKI

PostPosted: Tue Dec 18, 2018 8:30 am
by BLF
Bonjour,
J'ai une PCB BOX mais je n'ai aucun logiciel pour la faire fonctionner. Est que vous pourriez partager avec moi votre documentation sur le PCB module la PCB BOX année 2013 et les logiciels.
BLF

Re: Colinbus PCBBox

PostPosted: Tue Dec 18, 2018 6:49 pm
by BLF
Bonjour,
Est-que quelqu'un à utiliser la carte de pilotage : l'interpCNC V2 3 axes de SOPROLEC pour piloter la PCBBOX , si oui me montrer le schema de branchement pour la machine.
Merci
BLF