The Elektor Forum will close. See also this link. From Friday March 15st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

Colinbus Laboflex 30/pro

The electronics enthusiast's product design cycle

Colinbus Laboflex 30/pro

Postby Bullbasar » Mon Jul 11, 2016 2:18 pm

Hi to everyone,

I have a project with the laboflex 30/pro and as i was milling plexiglass the bit chew too much and got stuck.
I pressed the stop button reseted the machine and now the controller that is responsible for the milling-drilling process gives an message "Emergency" and does not do anything at all.
I searched everywhere i did anything that i could but couldn't get it run.
It seems that it is a flag that is stuck to the controller.
Is there a way that i can reset the machine hardware totally.

Thank you very much for your time reading it.
Bullbasar
 
Posts: 2
Joined: Thu May 19, 2016 9:20 am

Return to CAD, Simulation, PCBs, Making, 3D Printing

Who is online

Users browsing this forum: No registered users and 1 guest