Colinbus Laboflex 30/pro

The electronics enthusiast's product design cycle

Colinbus Laboflex 30/pro

Postby Bullbasar » Mon Jul 11, 2016 2:18 pm

Hi to everyone,

I have a project with the laboflex 30/pro and as i was milling plexiglass the bit chew too much and got stuck.
I pressed the stop button reseted the machine and now the controller that is responsible for the milling-drilling process gives an message "Emergency" and does not do anything at all.
I searched everywhere i did anything that i could but couldn't get it run.
It seems that it is a flag that is stuck to the controller.
Is there a way that i can reset the machine hardware totally.

Thank you very much for your time reading it.
Bullbasar
 
Posts: 2
Joined: Thu May 19, 2016 9:20 am

Return to CAD, Simulation, PCBs, Making, 3D Printing

Who is online

Users browsing this forum: No registered users and 1 guest