The Elektor Forum will close. See also this link. From Friday March 15st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

Elektor PCB prototyper - first PCB made!

The electronics enthusiast's product design cycle

Re: Elektor PCB prototyper - first PCB made!

Postby Opreican » Fri Dec 08, 2017 10:53 am

JohnF wrote:I have a PCBbox that I need to adjust the hole positions are out, but to do that I need access to the settings dialgue in PCBmodule has anyone the password for access to this?

I also have an elektor profiler that I require Colicam and colidrive for can anyone help with this?

I kind of had it, what you need.
I'll look for the password in my last project. If I find it. Send it ;)
All that we see or seem is but a dream within a dream.-Edgar Allan Poe
New hobby..Start from 2018.
User avatar
Opreican
 
Posts: 1
Joined: Fri Dec 08, 2017 10:34 am

Re: Elektor PCB prototyper - first PCB made!

Postby JohnF » Wed Dec 13, 2017 5:49 am

I have been using my PCB box with an error in hole positions, when doing double sided boards. but now I am working with a mix of SMD and through hole components the holes errors are causing a problem on the second side of the board. I would apreciate getting the password for the settings dialogue ib the PCBmodule, so I can adjust this error.
JohnF
 
Posts: 3
Joined: Sun Dec 03, 2017 12:39 pm

Previous

Return to CAD, Simulation, PCBs, Making, 3D Printing

Who is online

Users browsing this forum: No registered users and 1 guest

cron