A0 and A2 are swapped on the silk screen.
On the schematic, A0 goes to R172 and A2 goes to R174. The PCB silk screen & PCB picture in the book have them swapped
Cheers
The Elektor Forum will close. See also this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.
LM75 Silk Screen Problem
1 post
• Page 1 of 1
by gingganggooly » Mon Jun 25, 2012 12:00 am
Hi,
A0 and A2 are swapped on the silk screen.
On the schematic, A0 goes to R172 and A2 goes to R174. The PCB silk screen & PCB picture in the book have them swapped
Cheers
A0 and A2 are swapped on the silk screen.
On the schematic, A0 goes to R172 and A2 goes to R174. The PCB silk screen & PCB picture in the book have them swapped
Cheers
- gingganggooly
- Posts: 10
- Joined: Thu Jan 02, 2014 10:38 am
1 post
• Page 1 of 1
Return to Books | CDs | DVDs| Videos | Courses | Seminars | Webinars
Who is online
Users browsing this forum: No registered users and 1 guest