C Programming for Embedded uCs - Programmer's Notepad S

Post here on these publications

Postby warwick » Wed Oct 20, 2010 12:00 am

Book: C Programming for Embedded Microcontrollers by Warwick A. Smith

Problem: On pages 48 to 50, the book describes setting up Programmer's Notepad to run programs. This does not work with the latest version of Programmer's Notepad.

Solution: Change the settings in the dialog box shown in Figure 2.6 as follows -

Command: %d%n
Folder:
All the other setup instructions remain the same.

Thanks to Robert E. for bringing this to my attention.

Kind regards,
Warwick Smith
Attachments
pnp-run-tool.jpg
warwick
 
Posts: 11
Joined: Thu Jan 02, 2014 10:39 am

Return to Books | CDs | DVDs| Videos | Courses | Seminars | Webinars

Who is online

Users browsing this forum: No registered users and 1 guest