The Elektor Forum will close. See also this link. From Friday March 1st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.

C Programming for Embedded uCs - Programmer's Notepad S

Post here on these publications

Postby warwick » Wed Oct 20, 2010 12:00 am

Book: C Programming for Embedded Microcontrollers by Warwick A. Smith

Problem: On pages 48 to 50, the book describes setting up Programmer's Notepad to run programs. This does not work with the latest version of Programmer's Notepad.

Solution: Change the settings in the dialog box shown in Figure 2.6 as follows -

Command: %d%n
Folder:
All the other setup instructions remain the same.

Thanks to Robert E. for bringing this to my attention.

Kind regards,
Warwick Smith
Attachments
pnp-run-tool.jpg
warwick
 
Posts: 11
Joined: Thu Jan 02, 2014 10:39 am

Return to Books | CDs | DVDs| Videos | Courses | Seminars | Webinars

Who is online

Users browsing this forum: No registered users and 1 guest

cron