The Elektor Forum will close. See also this link. From Friday March 15st it is no longer possible to log in to the forum. However, the content of the forum will remain visible until the end of March. As of April 1st the forum will definitely go off the air.



Postby sandpiper » Sun Aug 18, 2013 12:00 am

Ref Elector Post, Project 13 ParkAid.
Have the .hex files been compiled/modified to use the 4 pin ultrasonic modules (DYP-ME007V1 or HC-SR04) instead of the 3 pin module
TS601P01 as specified by the designer Terry Hinrich?
Examination of the .c file suggests the code only supports the 3 pin module.
I am new to pic programming, so apologise for any stupid mistakes.
Posts: 2
Joined: Thu Jan 02, 2014 10:38 am

Postby thijsbeckers » Mon Aug 19, 2013 12:00 am

I forwarded your question. Please allow us some time to investigate and reply.
Posts: 1134
Joined: Thu Jan 02, 2014 10:37 am

Postby sandpiper » Sat Aug 31, 2013 12:00 am

Please ignore my previous message, it was my mistake. Sorry
Posts: 2
Joined: Thu Jan 02, 2014 10:38 am

Return to Automotive Electronics

Who is online

Users browsing this forum: No registered users and 1 guest