Page 1 of 1

PostPosted: Tue Jul 21, 2009 12:00 am
by boeingbrown
Hi All.

Although slightly off-topic probably of interest for all modellers/builders/designers/millers here.

If there are objects which cannot be milled for any reason there is the probability of what is called "3D printing", a technique where an object is completely build up of a material (in stead of that it is cut out of a material).

The website is rather chaotic, but nevertheless very complete.

How to (also on the site):


Re: Building 3D objects:

PostPosted: Tue Nov 29, 2016 3:16 pm
by Karlito