Het Elektor forum gaat sluiten. Zie ook deze link. Vanaf vrijdag 15 maart is het niet langer mogelijk om in te loggen op het forum. Wel blijft de inhoud van het forum nog zichtbaar tot het einde van de maand maart. Per 1 april gaat het forum definitief uit de lucht.

Combi C meter problem

FAQ en discussie

Postby hadihf » Thu May 31, 2007 12:00 am

Hi,
In ESR it is working OK. But when switch to C I get this error message..

Capacity Zero
Setpoint Error

How to correct this? I checked circuit and values are ok.


Regards
hadihf
 
Posts: 49
Joined: Thu Jan 02, 2014 10:37 am

Postby hadihf » Thu May 31, 2007 12:00 am

Hi,
I replaced the 7555 and it working ok now

Regards
hadihf
 
Posts: 49
Joined: Thu Jan 02, 2014 10:37 am

Postby thijsbeckers » Thu May 31, 2007 12:00 am

Good work! But "7555"?
thijsbeckers
 
Posts: 1134
Joined: Thu Jan 02, 2014 10:37 am

Postby hadihf » Thu May 31, 2007 12:00 am

Harris 7555 = Texas TLC555
hadihf
 
Posts: 49
Joined: Thu Jan 02, 2014 10:37 am

Postby thijsbeckers » Thu May 31, 2007 12:00 am

Ah!
thijsbeckers
 
Posts: 1134
Joined: Thu Jan 02, 2014 10:37 am

Postby hadihf » Thu May 31, 2007 12:00 am

[URL=http://www.upimages.net/out.php/i11104_ESR.jpg][IMG]http://www.upimages.net/out.php/t11104_ESR.jpg[/IMG][/URL]
hadihf
 
Posts: 49
Joined: Thu Jan 02, 2014 10:37 am

Postby hadihf » Thu May 31, 2007 12:00 am

Hi,
I think the rsolution for ESR & DCr should have been 0.00 ohms

Regards
hadihf
 
Posts: 49
Joined: Thu Jan 02, 2014 10:37 am

Postby wim-nl » Thu May 31, 2007 12:00 am

That's right.
That is why i bought me an other one, in Portugal for only 67 euro.
This one has a resolution of 0,01 - 99 ohm.
Works great.

wim-nl
 
Posts: 9
Joined: Thu Jan 02, 2014 3:43 pm


Return to 2005-09 Combi-C-meter

Who is online

Users browsing this forum: No registered users and 1 guest